31 de mayo de 2008

Primer solo de On an island, strato + tube driver con 12AT7


cambio de válvulas en mi Tube Driver ... experimentando

me anime, y le probé válvulas diferentes a mi BK Butler Tube Driver (TD).

- ¿cómo abrir la caja ... tiene 4 tornillos en la base (wha-wha) y dos tornillos en el frente.






le escribí a BK y me dijo: los tornillos de las bases. cuidado que el tubo va "pegado" para evitar que se salga durante el viaje de despacho.





- así fue, pegado con un pegamento ... lo abrí con un corta-cartón. corte en torno de la base del soquete que contiene el tubo.




probé
:
JJ ECC803S: un 12AX7 Large Plate.
sonaba bien, pero el drive estaba al 100%. me deja poco headroom ... ¿qué pasaba si me faltaba drive para tocar, por ejemplo, two minutes to midnight? la Eq. equilibrada diría yo.

luego probé el otro que tengo un 12AT7.....

The JJ ECC81 / 12AT7 tube is a low noise and low microphonic preamp tube. A good choice for phase inverters and reverb circuits calling for 12AT7 tubes.The ECC81 tube type is equivalent to the North American 12AT7 tube and can be used in any 12AT7 or ECC81 circuit.

con el 12AT7 bajó el ruido de mi circuito. el drive esta muy bien a las 12:00, es el que uso de overdrive.
quizás un sonido un poco abombado. se supone que debería probar el 12AU7 ...

veremos, habrá que mirar tubos NOS.

29 de mayo de 2008

Una amiga invitada por esta semana ..

Hay una amiga invitada a jugar ....
Una guitarra Hamer con cápsulas P-90.

voy a tratar de grabar algo con ellas ... y mi setup.

Gracias muchas a Andrés Vargas por la confianza ... maestro.

"The humbucking pickups were designed by the engineer Seth Lover, who sought a way of eliminating the 60 cycle hum and other interference that single coil pickups exhibited (single coil pickups include the P-90 pickup). His idea was very simple - make a pickup with two smaller pickup coils instead of one big coil, and wire the two coils in series and out-of-phase. This way the hum from one coil cancels the hum from the other. The resulting pickup was not merely one that had no hum, but also that the sound was different. Humbuckers generally produce a higher output signal and also a mellower tone with greater midrange and less treble frequencies. "

http://www.provide.net/~cfh/lpgold.html

la guitarra es:

Studio P-90 (GAPC) This double cutaway guitar begs you to take control. From the moment you start playing you’ll love its warm, smooth, bluesy tones. That great tone starts from a one-piece pattern grade mahogany body, which is capped with an ivoroid bound hard rock maple top. Coupled with our innovative three-piece stressed mahogany neck this resonant combination makes for an awesome tone machine. The rosewood fingerboard is hand-inlaid with genuine mother of pearl Victory markers and fretted with Hamer’s ultra-accurate nickel-silver frets. A pair of calibrated Seymour Duncan P90 pickups deliver all that solid tone to your amp.

TOP

Material: Maple
Configuration: Arched
Thickness: 5/8"

BODY
Material: Mahogany
L, W, T: 16" x 12.9" x 2"
Binding: Single Ply Ivoroid

NECK

Material: Mahogany
Shape: Vintage Round
Thickness: Vintage carve: .900" - .960"
Binding: Single Ply Ivoroid

FINGERBOARD

Material: Rosewood
Radius: 14 1/2"
Inlays: Victory
Fret Dimenions: Hamer Wide Oval: .100" x .050"
Nut Type/Width: Ivory, 1.650"
Scale Length: 24 3/4

PICKUPS

Neck Pickup: Seymour Duncan P-90
Middle Pickup: N/A
Bridge Pickup: Seymour Duncan P-90

ELECTRONICS

Controls: 2Vol,1 Tone
Switch: 3-Way Toggle

HARDWARE

Bridge: Tone Pros TOM
Tuners: Schaller

http://www.hamerguitars.com/?fa=detail&mid=391&sid=180#

Selector pasivo A/B

esto lo encontré en: http://www.fulltone.com/qaframe.html
es un selector A/B pasivo, de fácil construcción (DIY).

23 de mayo de 2008

Mis cápsulas ... Custom Shop Fat '50s

Do you want the sound of a '50s Strat®, but with a little bit more attitude?
Check out the Custom Shop Fat '50s. These calibrated pickups are constructed with hand beveled, staggered, Alnico 5 magnets and Formvar wire on the coils.
The Fat '50s deliver enhanced bass response without the harsh mid-range. The middle pickup is reverse wound/reverse polarity for hum canceling in positions 2 & 4.
The blues never sounded so sweet. OEM on Custom Shop Showmaster Series Stratocasters®. Available in white only, sold as set of 3 or as each.


Bridge Pickup
DC Resistance: 6.2K
Inductance: 2.8Henries

Middle Pickup
DC Resistance: 6.3K
Inductance: 2.75Henries

Neck Pickup
DC Resistance: 6.0K
Inductance: 2.4Henries

http://www.fender.com/products//search.php?partno=0992111000

22 de mayo de 2008

una guitarra para mi familia ..

a mi me gusta Gilmour,
a mi me gusta fender ...

y a mi hija le fascina Hello Kitty ...



PERFECTO!

21 de mayo de 2008

Improvisando sobre el solo de Another brick in the wall + bundler tube driver

otra improvisación ... una tarde de otoño...

Improvisando sobre el solo de Young Lust (muff)

es solo una improvisacion ...

Aprendiendo de tubos II

UPDATE ... http://kcanostubes.com/content/Default.asp
nuevo sitio para revisar


se supone que el tubo "hace" la diferencia.

revisen este link, tiene muy buenas explicaciones de tipos de tubos diferentes.
http://store.tubedepot.com/index.html

sin embargo yo fui directo a: http://store.tubedepot.com/no.html la sección de tubos N.O.S. (New Old Stock).
son tubos antiguos de verdad. la oferta es escasa y algunos tubos son bastante caros ...

a mi me llamaron la atención los siguientes:
http://store.tubedepot.com/nos-12ax7-telesp.html
http://store.tubedepot.com/nos-12ax7-mullard.html
http://store.tubedepot.com/nos-5814asiemens.html
http://store.tubedepot.com/nos-12au7-mullard.html
http://store.tubedepot.com/nos-12au7-rca-bp.html

voy a tratar de comprar algunos de estos para probarlos en el Butler Tube Driver y en que me hizo DSM Noisemaker.

4 de mayo de 2008

aprendiendo a convivir con el Hum ...

volvió el Tube Driver hecho por DSM Noisemaker.

tiene mucho más carácter y tonalidad que el TS-9.
veremos.

Rz

3 de mayo de 2008

Nuevo micrófono para grabar las guitarras eléctricas

acabo de comprar un micrófono nuevo.

es un clásico, un Shure SM 57.

es un micrófono dinámico que "oye" muy bien las frecuencias que necesitan oírse de una guitarra eléctrica.

lo probé con varias canciones. me puse los audífonos y grabé algunas cosas, el cambio es impresionante. menos Hum y Hiss, más percursividad. ahora el Dynacomp brilla!.

el cambio era necesario.

SM57 Instrument Microphone
The legendary Shure SM57 microphone is exceptional for musical instrument pickup and vocals. With its bright, clean sound and contoured frequency response, the SM57 is ideal for live sound reinforcement and recording. It has an extremely effective cardioid pickup pattern which isolates the main sound source while minimizing background noise. In the studio, it is excellent for recording drums, guitar, and woodwinds. The SM57’s outstanding performance, legendary reliability, and diversity of application make this "workhorse" the choice of performers, producers, and sound engineers worldwide.

SM57-LC : Without Cable
SM57-LCE : Without Cable, with 5/8-inch to 3/8-inch thread adapter for mounting on European stands

http://www.shure.com/proaudio/products/wiredmicrophones/us_pro_sm57-lc_content

Rz

RedZ On Line